LS 460 V8-4.6L (1UR-FSE) (2007)
^
Pressing the drill too firmly will cause the rivet to turn and result in the rivet NOT being drilled through.
^
Do NOT pry the rivet with the drill, because this may cause damage to the installation holes of the rivet or the drill bit.
(3) Using a vacuum cleaner remove the rivet fragments and shavings from the drilled area.
Remove the two screws at the rear edge of the door frame.
(4) Loosen the 5 belt line screws indicated by the arrows.
NOTE
These 5 screws do NOT have to be fully removed
(5) Remove the 4 screws and belt molding (See Figure 22).
NOTICE
Remove any remaining fragments of the 3 rivets on the molding assembly.
Repair Procedure: Part 1
Perform the required repairs as described below.
NOTE
The foam repairs (steps [A] through [F]) ONLY apply to 2007 model year vehicles produced BEFORE the Production Change VIN shown in the
Production Change Information table.
Part 1, Step A:
1. Add EPT foam behind the chrome belt molding.
Dimensions: 5 x 5 x 925 mm (0.20 x 0.20 x 36.40 in.)