lexus Workshop Repair Guides

Lexus Workshop Service and Repair Manuals

Components|Page 10459 > < Components|Page 10457
Page 1
background image

Antenna Amplifier: Service and Repair
Installation

AUDIO / VISUAL: AMPLIFIER ANTENNA: INSTALLATION

INSTALLATION

1. INSTALL AMPLIFIER ANTENNA ASSEMBLY

(a) Use non-residue solvent to clean the area on the glass where the antenna will be installed.

NOTE:
Do not use non-residue solvent to clean the antenna's contact points. Doing so may cause improper contact between the antenna and glass.

(b) Temporarily install the antenna with a new clip labeled A, and then install the antenna with the 2 nuts labeled B.

Torque: 14 Nm (143 kgf-cm, 10 ft-lbf)

NOTICE:
-

Just before installing the antenna to the glass, remove the protective cover of the antenna's contact points.

-

When removing the protective cover of the antenna's contact points, make sure the cover does not touch the contact points.

-

Never touch the contact points after removing the protective cover.

-

Do not reuse the clip labeled A.

(c) Attach the 4 clips labeled C.
(d) Connect the antenna connectors.

(e) Return the roof headlining to its original position.

for Standard Body: Refer to the following procedures  See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof
Headlining (for Standard Body)/Installation.
for Long Body: Refer to the following procedures  See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof
Headlining (for Long Body)/Installation.

2. INSTALL ASSIST GRIP SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof Headlining (for

Standard Body)/Installation

3. INSTALL ROOF SIDE REGISTER BEZEL RH (W/ Rear Cooler) See: Body and Frame/Interior Moulding / Trim/Headliner/Service and

Repair/Roof Headlining (for Standard Body)/Installation

4. INSTALL ROOF SIDE REGISTER BEZEL LH (W/ Rear Cooler) See: Body and Frame/Interior Moulding / Trim/Headliner/Service and

Repair/Roof Headlining (for Standard Body)/Installation

5. INSTALL COAT HOOK See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof Headlining (for Standard

Components|Page 10459 > < Components|Page 10457