LS 460 AWD V8-4.6L (1UR-FSE) (2009)
15. REMOVE NO. 2 ULTRASONIC SENSOR
(a) Remove the sensors from the 2 sensor retainers as shown in the illustration.
-
Be careful not to damage the retainer.
-
Do not forcibly remove the retainer from the bumper cover.
16. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER
(a) While heating the retainer using a dryer, pull the retainer lightly and remove the double-sided tape. Then remove the retainer.
Heating temperature:
40 to 60°C (104 to 140°F)
CAUTION:
Be careful of burns.
(b) Using a cloth or non-residue solvent, wipe off any tape residue on the bumper cover.
17. REMOVE NO. 2 ULTRASONIC SENSOR RETAINER
(a) While heating the retainer using a dryer, pull the retainer lightly and remove the double-sided tape. Then remove the retainer.
Heating temperature:
40 to 60°C (104 to 140°F)
CAUTION:
Be careful of burns.
(b) Using a cloth or non-residue solvent, wipe off any tape residue on the bumper cover.
Installation
PARK ASSIST / MONITORING: ULTRASONIC SENSOR (for Front Side): INSTALLATION
INSTALLATION
1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER
(a) Clean the bumper cover.
NOTICE:
-
When there is any dirt such as oil, dust and tape residue on the bumper cover, wipe it off using cloth, gauze, etc. that is soaked with
non-residue solvent.