LS 460 AWD V8-4.6L (1UR-FSE) (2009)
/Page-2962005.png)
(3) Check if there is clearance between the sensor tape and sensor installation hole.
HINT: If there is no clearance, adjust it by decreasing the number of times the tape is wrapped. If there is excessive clearance, adjust it by
increasing the number of times the tape is wrapped.
(c) Apply primer
(1) Cover the sensor installation hole with protective tape cut to a square with a length/ width of 25 mm (0.98 in.).
(2) Using a brush or felt, apply primer or equivalent to the retainer installation area.
NOTICE:
-
Use a clean brush or felt.
-
Do not allow primer to contact the front surface of the bumper cover.
(3) Do not touch the bumper cover until the primer has dried.
Recommended drying time:
10 minutes or more {23°C, (73°F)}
(4) Confirm that the primer has completely dried by touching the bumper cover. Then remove the protective tape.
(d) Install the 4 No. 1 ultrasonic sensor retainers.
(1) Remove the peeling paper from the retainer.
(2) Insert the sensor tip into the retainer hole area until the claws are attached.
-
Do not touch the adhesive part of the double-sided tape.
-
Do not allow foreign matter to contact the adhesive part of the double-sided tape.
