LS 460 AWD V8-4.6L (1UR-FSE) (2009)
NOTICE
There must be no gap at circle 1 (see Figure 30).
3. Attach sponge sealer (3 x 4 x 65 mm) just beside the tape.
NOTICE
There must be no gap at circle 2 (see Figure 30).
4. Install the modified lower cover to the front door belt molding.
5. Cover the clip area clearance by FIPG (Non-Silicon Type) as in Figure 31.
Step C: Add rubber sealer to outer door glass seal lip.
Add rubber sealer to outer door glass seal lip.
Rubber Sealer Dimensions: 1.5 x 4 x 740 mm (0.06 x 0.16 x 29.13 in.)
Attach the rubber sealer (refer to 1 in Figure 32) in the front door glass outer weatherstrip.
Rubber Sealer Dimensions: 1.5 x 4 x 740 mm (0.06 x 0.16 x 29.13 in.)
1. Clean the area of the molding where the rubber stabilizer will be installed. Make sure that the area is dry before installing the rubber stabilizer.