LS 460 AWD V8-4.6L (1UR-FSE) (2009)
(a) Attach the claw and install the module with the 2 bolts.
- Torque: 9.8 Nm (100 kgf-cm, 87 in-lbf)
(b) Connect the connector.
(c) Connect the air hose connector.
2. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate
Spring/Service and Repair/Installation
3. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate
Spring/Service and Repair/Installation
4. INSTALL REAR FLOOR FINISH PLATE See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Spring/Service and Repair/Installation
5. INSTALL LUGGAGE COMPARTMENT TRIM COVER SUB-ASSEMBLY FRONT See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk /
Liftgate Spring/Service and Repair/Installation
6. INSTALL NO. 1 COOLER COVER (W/ Rear Cooler) See: Heating and Air Conditioning/Housing Assembly HVAC/Service and Repair/Air
Conditioning Unit (for Rear Side)/Installation
7. INSTALL NO. 2 LUGGAGE COMPARTMENT NO. 2 TRIM HOOK (W/O Rear Cooler) See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk /
Liftgate Spring/Service and Repair/Installation
8. INSTALL LUGGAGE COMPARTMENT LIGHT ASSEMBLY See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Spring/Service
and Repair/Installation
9. INSTALL DECK TRIM SIDE BOARD LH See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Spring/Service and Repair/Installation
10. INSTALL DECK TRIM SIDE BOARD RH See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Spring/Service and Repair/Installation
11. INSTALL ROPE HOOK ASSEMBLY See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Spring/Service and Repair/Installation
12. INSTALL ROPE HOOK See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Spring/Service and Repair/Installation
13. INSTALL LUGGAGE COMPARTMENT FLOOR MAT SUB-ASSEMBLY See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate
Spring/Service and Repair/Installation
14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
15. INSTALL COWL TOP VENTILATOR LOUVER RH See: Starting and Charging/Charging System/Alternator/Service and Repair/Installation
16. PERFORM INITIALIZATION
(a) Perform initialization See: Testing and Inspection/Programming and Relearning/Repair Instruction - Initialization.
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable to the negative (-) battery terminal.
17. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Diagnosis System.