LS 460 AWD V8-4.6L (1UR-FSE) (2009)
Braking Sensor/Switch: Service and Repair
Removal
BRAKE CONTROL: BRAKE PEDAL STROKE SENSOR: REMOVAL
REMOVAL
NOTE:
While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or the
door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and open/close the
doors while the battery is connected.
1. REMOVE COWL TOP VENTILATOR LOUVER RH See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Removal
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTE:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and
settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery
terminal.
3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal
4. REMOVE INSTRUMENT SIDE PANEL LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal
5. REMOVE NO. 1 INSTRUMENT CLUSTER MOULDING See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service
and Repair/Removal
6. REMOVE STEERING COLUMN COVER See: Steering and Suspension/Steering/Steering Column/Service and Repair/Removal and
Replacement/Steering Column Assembly (W/ VGRS)/Removal
7. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY See: Sensors and Switches/Sensors and Switches - Wiper and Washer Systems/Wiper
Switch/Service and Repair/Removal
8. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal
9. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal
10. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal
11. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Driver Side Knee
Airbag Assembly/Removal
12. REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY
(a) Remove the 2 bolts and sensor.
(b) Disconnect the sensor connector.