LS 460 AWD V8-4.6L (1UR-FSE) (2009)
(b) Install the camshaft timing oil control valve with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
-
Do not allow foreign matter to contact the oil seal face of the camshaft timing oil control valve (connecting surface with cylinder head
cover).
-
Be careful that the O-ring is not cracked or moved out of place when installing the camshaft timing oil control valve.
(c) Connect the camshaft timing oil control valve connector.
3. INSTALL NO. 1 AIR CLEANER INLET See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Installation
4. INSTALL AIR CLEANER INLET COVER SUB-ASSEMBLY See: Powertrain Management/Fuel Delivery and Air Induction/Throttle
Body/Service and Repair/Installation
5. INSTALL V-BANK COVER SUB-ASSEMBLY See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Installation
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
7. INSTALL COWL TOP VENTILATOR LOUVER RH See: Starting and Charging/Charging System/Alternator/Service and Repair/Installation
8. PERFORM INITIALIZATION
(a) Perform initialization See: Testing and Inspection/Programming and Relearning/Repair Instruction - Initialization.
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
9. DRIVING TEST
(a) After the engine is warmed up, perform the driving test. Then check that the oil control valve operates normally.