LS 460 AWD V8-4.6L (1UR-FSE) (2009)
Exhaust Pipe: Service and Repair
Removal
1UR-FSE EXHAUST: EXHAUST PIPE: REMOVAL
REMOVAL
CAUTION:
-
The procedures should be performed by at least 2 people.
-
Wear protective gloves when removing the exhaust pipe.
-
The exhaust pipe is extremely hot immediately after the engine has stopped.
-
Confirm that the exhaust pipe has cooled down before removing it.
1. REMOVE NO. 2 DIFFERENTIAL SUPPORT PROTECTOR See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair/Removal and Replacement/Rear Drive Shaft Assembly/Removal
2. REMOVE NO. 1 DIFFERENTIAL SUPPORT PROTECTOR See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair/Removal and Replacement/Rear Drive Shaft Assembly/Removal
3. REMOVE NO. 6 ROCKER PANEL MOULDING PROTECTOR
(a) Remove the 2 clips, screw and protector.
4. REMOVE NO. 5 ROCKER PANEL MOULDING PROTECTOR
(a) Remove the 2 clips, screw and protector.
5. REMOVE REAR FLOOR SIDE MEMBER COVER LH
(a) Remove the clip, nut, 2 screws, 3 bolts and cover.
6. REMOVE REAR FLOOR SIDE MEMBER COVER RH
(a) Remove the clip, nut, 2 screws, 3 bolts and cover.
7. REMOVE FRONT FLOOR COVER LH
(a) Remove the 3 hole seals, 4 grommets and cover.
8. REMOVE FRONT FLOOR COVER RH