lexus Workshop Repair Guides

Lexus Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 13880 > < Initial Inspection and Diagnostic Overview
Page 2
background image

7. ADJUST, REPAIR OR REPLACE

NEXT -- Continue to next step.

8. CONFIRMATION TEST

NEXT -- END

Data List / Active Test

HORN: HORN SYSTEM: DATA LIST / ACTIVE TEST

DATA LIST / ACTIVE TEST

1. DATA LIST

HINT: Using the Techstream to read the Data List allows the values or states of switches, sensor, actuators and other items to be read without
removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts
or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when
deciding whether a part is faulty or not.

(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / (desired system) / Data List.
(e) According to the display on the Techstream, read the "Data List".

Body No.5

2. ACTIVE TEST

HINT: Using the Techstream to perform the Active Tests allows relays, VSVs and actuators and other items to be operated without removing
any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring
is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while
performing Active Tests.

(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Body No.5 / Active Test.

NOTE:
When a Body No. 5 (front light ECU) related vehicle switch is ON, Active Test items related to the vehicle switch are prohibited (double
operation prohibition). Check that the vehicle switches are OFF before performing Active Tests.

(e) According to the display on the Techstream, perform the "Active Test".

Body No.5

Initial Inspection and Diagnostic Overview|Page 13880 > < Initial Inspection and Diagnostic Overview