LS 460 AWD V8-4.6L (1UR-FSE) (2009)
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
1. CHECK BLINKING CONDITION OF LED7
(a) 5 seconds after the seat vibrator switch SW1 is pressed, check if LED7 blinks See: Body and Frame/Seats/Description and Operation/Seat
Vibration System.
OK:
LED7 blinds.
NG -- CHECK BLINKING CONDITION OF LED6
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (SEAT VIBRATOR MODULE - BATTERY AND BODY GROUND)
(a) Disconnect the S29 seat vibrator module connector.
(b) Measure the voltage and resistance according to the values in the table below.
Standard voltage:
Standard resistance: