LS 460 AWD V8-4.6L (1UR-FSE) (2009)
Parking Assist Control Module: Technical Service Bulletins
Parking Assist System - Initialization Procedure
L-SB-0097-08
September 11, 2008
Initialization of Advanced Parking Guidance System
Service Category
General
Section
Pre-Delivery Service
Market
USA
Applicability
Introduction
The Advanced Parking Guidance System assists the driver during parking and parallel parking by displaying an image of the area behind the vehicle and
controlling the steering wheel with the vehicle in reverse.
When the DCC fuses are removed or battery terminal disconnected the power source to the steering angle sensor is cut off. When the DCC fuses are
reinstalled or the battery terminal is reconnected the rear view monitor will operate but the steering angle sensor center position must be set through
system initialization before park assist will become operational.
Initialize the Advanced Parking Guidance System after installing the DCC fuses during Pre-delivery Service (PDS).
Any time the battery terminal has been disconnected, the Advanced Parking Guidance System MUST be initialized.
Warranty Information
Initialization Procedure
1.
Start the engine.
2.
Check if the Advanced Parking Guidance System is operative by moving the shift lever to the "R" position.