lexus Workshop Repair Guides

Lexus Workshop Service and Repair Manuals

Front Seat Side Airbag Assembly|Page 10064 > < Front Seat Side Airbag Assembly|Page 10062
Page 18
background image

(f) Deploy the airbag.

(1) Check that no one is inside the vehicle or within a 10 m (33 ft.) radius of the vehicle.
(2) Press the SST activation switch and deploy the airbag.
CAUTION:
-

When deploying the airbag, make sure that no one is near the vehicle.

-

The driver side knee airbag becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes after
deployment.

-

Use gloves and safety glasses when handling a driver side knee airbag with a deployed airbag.

-

Do not apply water to a driver side knee airbag with a deployed airbag.

-

Always wash your hands with water after completing the operation.

HINT: The airbag is deployed as the LED of the SST activation switch comes on.

2. DISPOSE OF DRIVER SIDE KNEE AIRBAG ASSEMBLY (WHEN NOT INSTALLED IN VEHICLE)

NOTE:
Be sure to follow the procedure detailed below when deploying the airbag.
HINT: Prepare a battery as the power source to deploy the airbag.

(a) Check the function of SST See: Steering Pad/Disposal.
(b) Remove the driver side knee airbag See: Driver Side Knee Airbag Assembly/Removal.

CAUTION:
-

When removing the driver side knee airbag, work must be started 90 seconds after the engine switch is turned off and the negative
(-) terminal cable is disconnected from the battery.

-

When storing the driver side knee airbag, keep the airbag deployment side facing upward.

(c) Using a service-purpose wire harness for the vehicle, tie down the driver side knee airbag to the tire.

Wire harness:
Stripped wire harness section
1.25 sq.mm or more (0.0019 sq.in or more)

CAUTION:
If the wire harness is too thin or an alternative object is used to tie down the driver side knee airbag, it may be snapped by the shock
when the airbag is deployed. Always use a wire harness for vehicle use with an area of at least 1.25 sq.mm (0.0019 sq.in).
HINT:
 To calculate the area of the stripped wire harness section: Area = 3.14 x (Diameter)2 divided by 4
(1) Position the driver side knee airbag inside the tire with the airbag deployment side facing inside.

Front Seat Side Airbag Assembly|Page 10064 > < Front Seat Side Airbag Assembly|Page 10062