LS 460 AWD V8-4.6L (1UR-FSE) (2009)
/Page-2658005.png)
-
Do not touch the front seat outer belt for at least 30 minutes after the seat belt pretensioner has been activated. It is very hot.
-
Use gloves and safety glasses when handling a front seat outer belt whose pretensioner has been activated.
-
Always wash your hands with water after completing the disposal.
-
Do not apply water to a front seat outer belt that has an activated pretensioner.
HINT: When scrapping a vehicle, activate the seat belt pretensioner, and then scrap the vehicle with the activated front seat outer belt
installed.
2. DISPOSE OF FRONT SEAT OUTER BELT ASSEMBLY (WHEN NOT INSTALLED IN VEHICLE)
NOTE:
Be sure to follow the procedures listed below when activating the seat belt pretensioner.
(a) Remove the front seat outer belt.
(1) Wind the seat belt with the retractor.
(2) When the seat belt is sufficiently wound, cut the seat belt approximately 100 mm (0.39 in.) from the retractor, as shown in the illustration.
HINT: The seat belt is designed so that winding the seat belt before pretensioner activation will decrease the pulling power of the seat belt
during pretensioner activation.
(b) Check if SST is functioning properly.
SST: 09082-00700
SST: 09082-00770
CAUTION:
When activating a seat belt pretensioner, always use the specified SST.
(c) Prepare SST for activation of the seat belt pretensioner.
(1) Connect SST (A) to SST (B). Then connect SST (B)'s connector to the seat belt pretensioner.
NOTE:
To avoid damaging SST connector and wire harness, do not lock the secondary lock of the twin lock.
