LS 460 AWD V8-4.6L (1UR-FSE) (2009)
Seat Type)/Installation
18. INSTALL REAR SEATBACK ASSEMBLY LH (for Power Seat) See: Body and Frame/Seats/Service and Repair/Rear Seat Assembly (for Power
Seat)/Installation
19. INSTALL REAR SEATBACK ASSEMBLY RH (for Power Seat) See: Body and Frame/Seats/Service and Repair/Rear Seat Assembly (for Power
Seat)/Installation
20. INSTALL REAR SEATBACK ASSEMBLY LH (for Ottoman) See: Body and Frame/Seats/Service and Repair/Rear Seat Assembly (for
Ottoman)/Installation
21. INSTALL REAR SEATBACK ASSEMBLY RH (for Ottoman) See: Body and Frame/Seats/Service and Repair/Rear Seat Assembly (for
Ottoman)/Installation
22. CONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH
(a) Install the floor end of the rear seat outer belt assembly LH with the bolt.
Torque: 42 Nm (428 kgf-cm, 31 ft-lbf)
NOTE:
Do not allow the anchor part of the rear seat 3 point type belt assembly LH to overlap the protruding parts of the floor panel.
(b) Check if the ELR locks.
NOTE:
The check should be performed with the outer belt assembly installed.
(1) With the belt assembly installed, check that the belt locks when it is pulled out quickly.
23. CONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH
(a) Use the same procedures described for the LH side.
24. CONNECT REAR SEAT OUTER BELT ASSEMBLY CENTER
(a) for Power Seat:
Install the floor end of the rear seat outer belt assembly center with the nut.
Torque: 42 Nm (428 kgf-cm, 31 ft-lbf)
NOTE:
Do not allow the anchor part of the rear seat outer belt assembly to overlap the protruding parts of the floor panel.
(b) for Fixed Seat Type:
Install the floor end of the rear seat outer belt assembly center with the nut.
Torque: 42 Nm (428 kgf-cm, 31 ft-lbf)
NOTE:
Do not allow the anchor part of the rear seat outer belt assembly to overlap the protruding parts of the floor panel.