LS 460 AWD V8-4.6L (1UR-FSE) (2009)
(c) Using 2 SST, install the steering rack end sub-assembly (LH side).
SST: 09922-10010
Without SST - Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)
With SST - Torque: 110 Nm (1122 kgf-cm, 81 ft-lbf)
-
Use a torque wrench with a fulcrum length of 345 mm (1.13 ft.).
-
This torque value is effective when SST is parallel to the torque wrench.
HINT: Using SST, hold the steering rack and install the steering rack end sub-assembly.
(d) Using a brass bar and a hammer, stake the 2 claw washers.
NOTE:
Avoid any impact to the steering rack.
2. INSTALL STEERING RACK BOOT NO.1
(a) Apply silicon grease to the inside of the small opening of the steering rack boot No.1 (LH side).
(b) Temporarily install a new steering rack boot No.1 clamp to the large opening of the steering rack boot No.1 (LH side) at the position shown by