LS 460 AWD V8-4.6L (1UR-FSE) (2009)
(j) Remove the overflow plug. At the proper fluid inspection temperature, check the fluid amount.
If the ATF flows from the overflow tube in a thin stream, the fluid amount is normal.
If the ATF does not flow from the overflow tube, remove the refill plug, and then add ATF into the refill hole until ATF flows from the
overflow tube.
(k) Install a new gasket and the overflow plug.
Torque: 20 Nm (204 kgf-cm, 15 ft-lbf)
(l) Install a new O-ring and the refill plug.
Torque: 39 Nm (398 kgf-cm, 29 ft-lbf)
(m)Lower the vehicle.
(n) Turn the engine switch off.
(o) W/ Air Suspension:
Disconnect the terminals 11 (OPB) and 4 (CG) of the DLC3.