LS 460 AWD V8-4.6L (1UR-FSE) (2009)
2. Align the center of the EPT foam with the location as shown in the illustration by the red arrow (See Figure 42).
3. Attach sponge sealer (4 x 7 x 70 mm) to door panel at back corner of belt line.
A. Attach the sponge sealer (4 x 7 x 70 mm) starting at Arrow 2 aligning it with the door panel flange.
NOTICE
The sponge sealer (4 x 7 x 70 mm) should contact the flange of door panel.
Repair Procedure: Assembly Hints
NOTE
These hints only apply to vehicles that received the foam repairs (2007 model year vehicles produced BEFORE the Production Change VIN shown
in the Production Change Information table).
During assembly be aware of the following areas where care MUST be taken.