LS 460 RWD V8-4.6L (1UR-FSE) (2010)
HINT
When it is difficult to press with your hands, use a resin spatula to press it.
NOTICE:
*
When it is difficult to press with your hands, use a resin spatula to press it.
*
The retainer's double-sided tape cannot be reused. If the retainer is not installed properly, remove the retainer and perform the
installation procedures from the beginning again.
2. INSTALL NO. 3 LUGGAGE ROOM WIRE See: Body and Frame/Bumper/Rear Bumper/Service and Repair/Overhaul/Reassembly
3. INSTALL REAR BUMPER COVER See: Body and Frame/Bumper/Rear Bumper/Service and Repair/Removal and Replacement/Installation
4. INSTALL REAR BUMPER PLATE LH See: Body and Frame/Bumper/Rear Bumper/Service and Repair/Removal and Replacement/Installation
5. INSTALL REAR BUMPER PLATE RH
HINT
Use the same procedure described for the LH side.
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some system need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning.
7. INSTALL COWL TOP VENTILATOR LOUVER RH See: Starting and Charging/Charging System/Alternator/Service and Repair/Removal and
Replacement/Installation