LS 460 RWD V8-4.6L (1UR-FSE) (2010)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Installation
BRAKE CONTROL: BRAKE ACTUATOR: INSTALLATION
NOTICE:
While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or
the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and
open/close the doors while the battery is connected.
1. INSTALL BRAKE ACTUATOR
NOTICE:
Do not remove the hole plug before installing a new brake actuator because the brake actuator is filled with brake fluid.
(a) Install the No. 3 brake actuator bracket to the brake actuator with the 3 bolts.
Torque : 9.3 Nm (95 kgf-cm, 82 in-lbf)
NOTICE:
After temporarily installing either bolt A or B, tighten the remaining bolts.
(b) Install the 3 cushions and 3 spacers to the bracket.