LS 460 RWD V8-4.6L (1UR-FSE) (2010)
Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf)
8. INSTALL NO. 1 RESERVOIR HOSE
(a) Install the reservoir connector (labeled A) to the No. 1 reservoir hose (labeled B) with the hose clip (labeled C) as shown in the illustration.
Length "A":
4.0 to 7.0 mm (0.158 to 0.276 in.)
(b) With the paint mark on the hose's tip facing the top of the vehicle, install the No. 1 reservoir hose (labeled B) to the master cylinder with the
hose clip (labeled D).
HINT
Install the hose clip so that its claws face the top of the vehicle.
9. INSTALL BRAKE FLUID RESERVOIR
(a) Connect the No. 1 reservoir hose (labeled A) and No. 2 brake actuator hose (labeled B) to the reservoir. The reservoir connector connecting
procedure must be followed as described below: