LS 460 RWD V8-4.6L (1UR-FSE) (2010)
Brake Master Cylinder: Overhaul
Disassembly
BRAKE: BRAKE MASTER CYLINDER: DISASSEMBLY
1. REMOVE BRAKE STROKE SIMULATOR TUBE
(a) Using a union nut wrench (10 mm), disconnect the brake stroke simulator tube from the brake master cylinder with simulator.
2. REMOVE BRAKE MASTER CYLINDER BRACKET
(a) Remove the 2 nuts (labeled A), brake master cylinder bracket (labeled B) and brake master cylinder gasket (labeled C).
3. REMOVE BRAKE STROKE SIMULATOR CYLINDER SUB-ASSEMBLY
(a) Remove the 2 bolts (labeled A), brake stroke simulator bracket (labeled B), brake master cylinder gasket (labeled C) and brake stroke
simulator cylinder (labeled D).
4. REMOVE MASTER CYLINDER PUSH ROD CLEVIS
(a) Remove the push rod clevis and lock nut.
HINT
If the protrusion of the push rod in relation to the push rod clevis is measured beforehand, it is easier to perform the brake pedal
height adjustment after the brake master cylinder with simulator is installed.