LS 460 RWD V8-4.6L (1UR-FSE) (2010)
38. INSTALL NO. 1 DIFFERENTIAL SUPPORT PROTECTOR See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair/Installation
39. INSTALL NO. 2 DIFFERENTIAL SUPPORT PROTECTOR See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair/Installation
40. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH See: Body and Frame/Doors, Hood and Trunk/Trunk /
Liftgate/Trunk / Liftgate Spring/Service and Repair/Installation
41. INSTALL DECK TRIM SIDE BOARD LH See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Spring/Service and
Repair/Installation
42. INSTALL REAR FLOOR FINISH PLATE See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Spring/Service and
Repair/Installation
43. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk /
Liftgate Spring/Service and Repair/Installation
44. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
45. INSTALL COWL TOP VENTILATOR LOUVER RH See: Starting and Charging/Charging System/Alternator/Service and Repair/Removal and
Replacement/Installation
46. PERFORM INITIALIZATION
(a) Perform initialization See: Testing and Inspection/Programming and Relearning.
NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
47. ADJUST PARKING BRAKE SHOE CLEARANCE
(a) Adjust parking brake shoe clearance See: Adjustments.
NOTICE:
If the parking brake shoe clearance is not adjusted, the cable end may be damaged.
48. INSTALL REAR WHEEL See: Steering and Suspension/Suspension/Stabilizer Bar/Service and Repair/Rear Stabilizer Bar/Installation
49. ADJUST VEHICLE HEIGHT
(a) Adjust vehicle height See: Sensors and Switches/Sensors and Switches - Steering and Suspension/Sensors and Switches - Suspension/Ride
Height Sensor/Adjustments.
50. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
(a) Inspect and adjust the rear wheel alignment See: Maintenance/Alignment/Service and Repair/Rear Wheel Alignment.
51. INSPECT SPEED SENSOR SIGNAL
(a) Inspect the speed sensor signal See: Antilock Brakes / Traction Control Systems/Testing and Inspection/Scan Tool Testing and
Procedures/Test Mode Procedure.
52. PERFORM CALIBRATION
(a) Clear the electric parking brake ECU memory and acquire tension sensor zero point See: Testing and Inspection/Programming and
Relearning.
53. PERFORM PARKING BRAKE SHOE BEDDING
(a) Perform parking brake shoe bedding See: Testing and Inspection/Programming and Relearning.
54. ADJUST HEADLIGHT AIMING
(a) Adjust headlight aiming See: Lighting and Horns/Headlamp/Adjustments.