LS 460 RWD V8-4.6L (1UR-FSE) (2010)
(5) Turn the engine switch on (IG). Reading the value of the stroke sensor 1 shown on the data monitor, turn the sensor slowly to the right and
left to adjust the output voltage to the standard voltage.
Standard voltage:
0.8 to 1.2 V
(6) Tighten the 2 bolts.
Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf)
NOTICE:
Do not depress the brake pedal after turning the engine switch on (IG).
2. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and
Replacement/Driver Side Knee Airbag Assembly/Installation
3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Installation
4. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Installation
5. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Installation
6. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY See: Sensors and Switches/Sensors and Switches - Wiper and Washer Systems/Wiper
Switch/Service and Repair/Installation
7. INSTALL STEERING COLUMN COVER See: Steering and Suspension/Steering/Steering Column/Service and Repair/Removal and
Replacement/Steering Column Assembly (W/ VGRS)/Installation
8. INSTALL NO. 1 INSTRUMENT CLUSTER MOULDING See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Installation
9. INSTALL INSTRUMENT SIDE PANEL LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Installation
10. INSTALL INSTRUMENT PANEL FINISH PANEL END LH See: Body and Frame/Interior Moulding / Trim/Console/Service and
Repair/Removal and Replacement/Front Console Box (w/o Rear Seat Entertainment System)/Installation
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning.
12. INSTALL COWL TOP VENTILATOR LOUVER RH See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Installation
13. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Diagnosis System.
14. CHECK AND CLEAR DTC