LS 460 RWD V8-4.6L (1UR-FSE) (2010)
Removal
BRAKE CONTROL: REAR SPEED SENSOR: REMOVAL
NOTICE:
While the battery is connected, even if the engine switch is off, the brake control system activates when the brake pedal is depressed or
the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal and
open/close the doors while the battery is connected.
HINT
*
The procedures listed below are for the RH side.
*
Other than areas where instructions are provided, Use the same procedures for the LH side and RH side.
1. REMOVE COWL TOP VENTILATOR LOUVER RH See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Removal
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
NOTICE:
*
w/ Navigation System (for HDD):
*
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table
before disconnecting the cable from the negative (-) battery terminal.
Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:
*
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning.
3. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk /
Liftgate Spring/Service and Repair/Removal
4. REMOVE ROPE HOOK ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Spring/Service and