LS 460 RWD V8-4.6L (1UR-FSE) (2010)
Oil Pressure Sender: Service and Repair
Installation
1UR-FSE LUBRICATION: OIL PRESSURE SWITCH: INSTALLATION
1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY
(a) Apply adhesive to 2 or 3 threads of the switch.
Adhesive:
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
(b) Using a 24 mm deep socket wrench, install the switch.
Torque : 15 Nm (153 kgf-cm, 11 ft-lbf)
NOTICE:
Do not start the engine within 1 hour after installation.
(c) Connect the switch connector.
2. INSTALL NO. 1 ENGINE UNDER COVER See: Cooling System/Coolant/Service and Repair
3. INSPECT FOR ENGINE OIL LEAK
(a) Start the engine. Make sure that there are no oil leaks from the area that was worked on.