LS 460 RWD V8-4.6L (1UR-FSE) (2010)
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory
and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative
(-) battery terminal.
3. REMOVE V-BANK COVER SUB-ASSEMBLY See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Removal
4. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY See: Powertrain Management/Fuel Delivery and Air Induction/Throttle
Body/Service and Repair/Removal
5. REMOVE NO. 1 AIR CLEANER INLET See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Removal
6. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 1)
(a) Disconnect the camshaft timing oil control valve connector.
(b) Remove the bolt and camshaft timing oil control valve.
(c) Remove the O-ring from the camshaft timing oil control valve.
7. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 2)
(a) Disconnect the camshaft timing oil control valve connector.
(b) Remove the bolt and camshaft timing oil control valve.
(c) Remove the O-ring from the camshaft timing oil control valve.
Installation
1UR-FSE ENGINE CONTROL SYSTEM: CAMSHAFT OIL CONTROL VALVE: INSTALLATION
1. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Bank 1)
(a) Apply a light coat of engine oil to a new O-ring, and install it to the camshaft timing oil control valve.
(b) Install the camshaft timing oil control valve with the bolt.
Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)