LS 460 RWD V8-4.6L (1UR-FSE) (2010)
/Page-910004.png)
timing chain cover).
*
When installing the camshaft timing control with EDU motor, do not use excessive force.
*
Do not drop the camshaft timing control with EDU motor. If dropped, replace it.
*
Do not disassemble the camshaft timing control with EDU motor. If disassembled, replace it.
HINT
*
Check that [L] is printed on the label of the camshaft timing control with EDU motor.
*
When installing the camshaft timing control with EDU motor, be sure to align the timing chain cover knock pin with the camshaft
timing control with EDU motor pin hole.
*
Install the camshaft timing control with EDU motor with the arrow facing upward.
(e) Connect the 2 camshaft timing control with EDU motor connectors and engine wire clamp.
2. INSTALL CAMSHAFT TIMING CONTROL WITH EDU MOTOR ASSEMBLY RH
(a) Turn the camshaft timing gear's eccentric shaft keyway part counterclockwise by hand and set it to the maximum retard angle.
HINT
*
When the cam of the camshaft lifts the valve, the eccentric shaft becomes difficult to turn.
*
The position where the eccentric shaft stops is the maximum retard angle.
NOTICE:
When turning the eccentric shaft keyway part, do not use any tools as the keyway part may be damaged.
(b) Turn the eccentric shaft clockwise until the groove labeled A and mark labeled B are aligned as shown in the illustration.
HINT
Make sure that the groove labeled A is positioned as close as possible to the center of the mark labeled B.
(c) Install a new O-ring to the timing chain cover.
(d) Align the joint of the camshaft timing control with EDU motor and the keyway of the camshaft timing gear assembly, and install the motor
with the 3 bolts.
Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)
NOTICE:
*
Do not allow foreign matter to contact the oil seal face of the camshaft timing control with EDU motor (connecting surface with
timing chain cover).
*
When installing the camshaft timing control with EDU motor, do not use excessive force.
*
Do not drop the camshaft timing control with EDU motor. If dropped, replace it.
*
Do not disassemble the camshaft timing control with EDU motor. If disassembled, replace it.
HINT
*
Check that [R] is printed on the label of the camshaft timing control with EDU motor.
*
When installing the camshaft timing control with EDU motor, be sure to align the timing chain cover knock pin with the camshaft
timing control with EDU motor pin hole.
*
Install the camshaft timing control with EDU motor with the arrow facing upward.
(e) Install the engine wire bracket with the bolt.
Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)
