LS 460 RWD V8-4.6L (1UR-FSE) (2010)
(c) Install the O-ring to the cooler refrigerant discharge hose.
(d) Install the cooler refrigerant discharge hose to the cooler compressor with the bolt.
Torque : 9.8 Nm (100 kgf-cm, 7 ft-lbf)
4. CONNECT SUCTION HOSE SUB-ASSEMBLY
(a) Remove the attached vinyl tape from the hose.
(b) Sufficiently apply compressor oil to a new O-ring and the fitting surface of the cooler compressor.
Compressor oil:
ND-OIL 8 or equivalent
(c) Install the O-ring to the cooler refrigerant suction hose.
(d) Install the cooler refrigerant suction hose to the cooler compressor with the bolt.
Torque : 9.8 Nm (100 kgf-cm, 7 ft-lbf)
5. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY (for Bank 1) See: Engine, Cooling and Exhaust/Exhaust System/Exhaust
Manifold/Service and Repair/Installation
6. INSTALL NO. 2 EXHAUST MANIFOLD HEAT INSULATOR See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Manifold/Service
and Repair/Installation
7. INSTALL POWER STEERING LINK ASSEMBLY
(a) w/ VGRS:
Install the power steering link See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine/Installation.
(b) w/o VGRS:
Install the power steering link See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine/Installation.
8. INSTALL NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY
(a) w/ VGRS:
Install the No. 2 steering intermediate shaft See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine/Installation.
(b) w/o VGRS:
Install the No. 2 steering intermediate shaft See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine/Installation.
9. INSTALL STEERING SLIDING WITH SHAFT YOKE SUB-ASSEMBLY
(a) w/ VGRS:
Install the steering sliding with shaft yoke See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and