LS 460 RWD V8-4.6L (1UR-FSE) (2010)
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:
NG -- REPLACE IGNITION RELAY NO. 2 (IG2)
OK -- GO TO SMART ACCESS SYSTEM WITH PUSH-BUTTON START See: Starting and Charging/Starting System/Testing and
Inspection/Symptom Related Diagnostic Procedures/Power Source Mode does not Change
6. INSPECT ECM (MREL VOLTAGE)
(a) Turn the engine switch on (IG).
(b) Measure the voltage according to the value(s) in the table below.
Standard voltage:
NG -- REPLACE ECM See: Service and Repair/Removal
OK -- Continue to next step.
7. CHECK FUSE (EFI MAIN2)
(a) Remove the EFI MAIN2 fuse from the engine room No. 2 relay block.