LS 460 RWD V8-4.6L (1UR-FSE) (2010)
/Page-2373006.png)
CAUTION:
*
The front passenger side knee airbag assembly becomes extremely hot when the airbag is deployed, so do not touch it for at least
30 minutes after deployment.
*
Use gloves and safety glasses when handling a front passenger side knee airbag with a deployed airbag.
*
Do not apply water to a front passenger side knee airbag with a deployed airbag.
*
Always wash your hands with water after completing the operation.
(1) Remove the front passenger side knee airbag from the tire.
(2) Place the front passenger side knee airbag in a plastic bag, tie it tightly and dispose of it in the same way as other general parts.
Curtain Shield Airbag Assembly
SUPPLEMENTAL RESTRAINT SYSTEM: CURTAIN SHIELD AIRBAG ASSEMBLY: DISPOSAL
HINT
When scrapping a vehicle equipped with the SRS or disposing of the curtain shield airbag assembly, be sure to deploy the airbag first
in accordance with the procedure described below. If any abnormality occurs with the airbag deployment, contact the SERVICE
DEPT. of TOYOTA MOTOR SALES, U.S.A., INC.
CAUTION:
*
Never dispose of a curtain shield airbag that has an unactivated airbag.
*
The airbag produces an exploding sound when it is deployed, so perform the operation outdoors and where it will not create a
nuisance to nearby residents.
*
When deploying the airbag, always use the specified SST (SRS Airbag Deployment Tool). Perform the operation in a place away
from electrical noise.
*
When deploying the airbag, perform the operation at least 10 m (33 ft.) away from the curtain shield airbag.
*
The curtain shield airbag becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes after
deployment.
*
Use gloves and safety glasses when handling a curtain shield airbag with a deployed airbag.
*
Do not apply water to a curtain shield airbag with a deployed airbag.
*
Always wash your hands with water after completing the operation.
*
An airbag or pretensioner may be activated by static electricity. To prevent this, be sure to touch a metal surface with bare hands
to discharge static electricity before performing this procedure.
1. DISPOSE OF CURTAIN SHIELD AIRBAG ASSEMBLY (WHEN INSTALLED IN VEHICLE)
HINT
Prepare a battery as the power source to deploy the airbag.
(a) Check the function of SST See: Steering Pad.
(b) Read the precaution See: Service Precautions.
(c) Disconnect the cable from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
