LS 460 RWD V8-4.6L (1UR-FSE) (2010)
(k) Connect the switch connector.
2. CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY
(a) Temporarily connect the shifting rod to the connecting rod swivel with the nut.
HINT
The nut is tightened to a torque specification during the shift lever position adjustment procedure.
3. ADJUST SHIFT LEVER POSITION
(a) Adjust the shift lever position See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shifter A/T/Adjustments/AA80F
Automatic Transmission.
4. INSTALL FRONT FLOOR NO. 1 HEAT INSULATOR See: Transmission and Drivetrain/Drive/Propeller Shafts, Bearings and
Joints/Drive/Propeller Shaft/Service and Repair/Removal and Replacement/Installation
5. INSTALL FRONT EXHAUST PIPE ASSEMBLY
(a) Install the front exhaust pipe See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and Repair/Installation.
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning.
7. INSTALL COWL TOP VENTILATOR LOUVER See: Starting and Charging/Charging System/Alternator/Service and Repair/Removal and
Replacement/Installation
8. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a) Inspect the switch See: Testing and Inspection/AA80F Automatic Transmission/On-Vehicle Inspection.