LS 460 RWD V8-4.6L (1UR-FSE) (2010)
2. INSTALL FRONT WHEEL
Torque : 140 Nm (1428 kgf-cm, 103 ft-lbf)
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. INSTALL COWL TOP VENTILATOR LOUVER RH See: Starting and Charging/Charging System/Alternator/Service and Repair/Removal and
Replacement/Installation
5. CHECK VEHICLE HEIGHT
NOTICE:
If the height control sensor link is removed, check the vehicle height.
(a) Change the height control switch from the "NORM" position to the "HIGH" position and back to the "NORM" position again.
(b) for Front 2WD:
Measure the vehicle height See: Maintenance/Alignment/Service and Repair/Front Wheel Alignment.
(c) for Front AWD:
Measure the vehicle height See: Maintenance/Alignment/Service and Repair/Front Wheel Alignment.
6. ADJUST VEHICLE HEIGHT
NOTICE:
If the height control sensor has been replaced, be sure to adjust the vehicle height.
(a) Adjust the vehicle height See: Adjustments.
7. PERFORM INITIALIZATION
(a) Perform initialization See: Testing and Inspection/Programming and Relearning.
NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
8. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Diagnosis System.
9. ADJUST HEADLIGHT ASSEMBLY
(a) Adjust the headlight See: Lighting and Horns/Headlamp/Adjustments.