LS 460 RWD V8-4.6L (1UR-FSE) (2010)
(b) Install a new gasket and the oil pan to the transmission case with the 9 bolts.
Torque : 7.4 Nm (75 kgf-cm, 65 in-lbf)
NOTICE:
*
Make sure that there is no oil or foreign matter on the gasket seal surface and oil pan contact surface.
*
Install the gasket so that there is no slack in the gasket, and that the seal surface's entire circumference is level.
*
Make sure that the 9 gasket drop prevention protrusions are set on the oil pan.
*
When tightening the oil pan, make sure that the gasket is not pinched between the gasket tightening area's sleeve and the
transmission's seal surface.
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
8. INSTALL COWL TOP VENTILATOR LOUVER See: Starting and Charging/Charging System/Alternator/Service and Repair/Removal and
Replacement/Installation
9. ADD AUTOMATIC TRANSMISSION FLUID
(a) Add automatic transmission fluid See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and
Repair/Procedures/AA80E Automatic Transmission.
10. PERFORM INITIALIZATION
(a) Perform initialization See: Testing and Inspection/Programming and Relearning.
NOTICE: