lexus Workshop Repair Guides

Lexus Workshop Service and Repair Manuals

Removal and Replacement|Page 7771 > < Removal and Replacement|Page 7769
Page 6
background image

5. CONNECT STEERING SLIDING YOKE WITH SHAFT SUB-ASSEMBLY   See: Steering Column/Service and Repair/Removal and

Replacement/Steering Column Assembly (W/ VGRS)/Installation

6. INSTALL FRONT SUSPENSION MEMBER PROTECTOR LOWER   See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal

and Replacement/Engine/Installation

7. INSTALL NO. 2 ENGINE UNDER COVER   See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and

Replacement/Engine/Installation

8. INSTALL NO. 1 ENGINE UNDER COVER   See: Engine, Cooling and Exhaust/Cooling System/Coolant/Service and Repair

9. INSTALL FRONT WHEELS

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

11. INSTALL COWL TOP VENTILATOR LOUVER RH   See: Starting and Charging/Charging System/Alternator/Service and Repair/Removal and

Replacement/Installation

12. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

13. PERFORM INITIALIZATION

(a) Perform initialization    See: Testing and Inspection/Programming and Relearning.

NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

14. CHECK SUSPENSION CONTROL SYSTEM

(a) Check the suspension control system    See: Sensors and Switches - Steering and Suspension/Sensors and Switches - Suspension/Ride Height

Sensor/Adjustments.

15. ADJUST HEADLIGHT AIMING

(a) Adjust headlight aiming    See: Lighting and Horns/Headlamp/Adjustments.

16. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

(a) Inspect and adjust front wheel alignment    See: Alignment/Service and Repair/Front Wheel Alignment.

17. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light    See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic

Overview/Diagnosis System.

18. INITIALIZE ROTATION ANGLE SENSOR AND CALIBRATE TORQUE SENSOR ZERO POINT

(a) Initialize rotation angle sensor and calibrate torque sensor zero point    See: Testing and Inspection/Programming and Relearning/Power

Steering System.

Components

POWER STEERING: STEERING GEAR (w/ VGRS): COMPONENTS

Removal and Replacement|Page 7771 > < Removal and Replacement|Page 7769