LS 460 RWD V8-4.6L (1UR-FSE) (2010)
/Page-2085003.png)
4. REMOVE FRONT WHEELS
5. REMOVE NO. 1 ENGINE UNDER COVER See: Engine, Cooling and Exhaust/Cooling System/Coolant/Service and Repair
6. REMOVE FRONT SUSPENSION MEMBER PROTECTOR LOWER See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal
and Replacement/Engine/Removal
7. REMOVE NO. 2 ENGINE UNDER COVER See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine/Removal
8. DISCONNECT STEERING SLIDING YOKE WITH SHAFT SUB-ASSEMBLY See: Steering/Steering Column/Service and Repair/Removal
and Replacement/Steering Column Assembly (W/ VGRS)/Removal
9. DISCONNECT TIE ROD ASSEMBLY LH See: Steering/Steering Gear/Service and Repair/Removal and Replacement/Steering Gear (w/
VGRS)/Removal
10. DISCONNECT TIE ROD ASSEMBLY RH See: Steering/Steering Gear/Service and Repair/Removal and Replacement/Steering Gear (w/
VGRS)/Removal
11. REMOVE POWER STEERING LINK ASSEMBLY See: Steering/Steering Gear/Service and Repair/Removal and Replacement/Steering Gear
(w/ VGRS)/Removal
12. DISCONNECT SPEED SENSOR CONNECTOR See: Wheel Hub/Service and Repair/Front Axle Hub/Removal
13. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH See: Wheel Hub/Service and Repair/Front Axle Hub/Removal
14. REMOVE FRONT DISC See: Brakes and Traction Control/Disc Brake System/Service and Repair/Removal and Replacement/Front Brake
(except 6-Pot Caliper)/Removal
15. REMOVE FRONT DISC BRAKE DUST COVER LH See: Wheel Hub/Service and Repair/Front Axle Hub/Removal
16. REMOVE FRONT NO. 1 SUSPENSION LOWER ARM ASSEMBLY LH
(a) Remove the clip and nut.
(b) Install 2 spacers (SST spacer A) onto the front No. 1 suspension lower arm assembly LH so that there is a space of approximately 1 mm
(0.0394 in.) between the arm and spacers.
SST : 09960-20010
09961-02050
NOTICE:
*
Make sure to install the spacers (SST spacer A) as the steering knuckle spacer may shift.
*
As SST may become damaged, make sure the space between the arm and spacers is not 1 mm (0.0394 in.) or less.
