LS 460 RWD V8-4.6L (1UR-FSE) (2010)
*
The procedures listed below are for the LH side.
1. REMOVE REAR WHEEL
2. REMOVE NO. 2 DIFFERENTIAL SUPPORT PROTECTOR See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair/Removal
3. REMOVE REAR SPEED SENSOR LH See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel Speed
Sensor/Service and Repair/Rear Speed Sensor/Removal
4. REMOVE LOAD SENSING VALVE SENSOR BRACKET See: Sensors and Switches - Suspension/Ride Height Sensor/Service and
Repair/Height Control Sensor (for Rear LH)/Removal
5. REMOVE REAR STABILIZER LINK ASSEMBLY LH See: Stabilizer Bar/Service and Repair/Rear Stabilizer Bar/Removal
6. DISCONNECT REAR SHOCK ABSORBER ASSEMBLY LH (w/o Air Suspension) See: Rear Upper Arm/Removal
7. DISCONNECT PNEUMATIC CYLINDER WITH REAR SHOCK ABSORBER ASSEMBLY LH (w/ Air Suspension) See: Rear Upper
Arm/Removal
8. REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY LH
(a) Using a plastic-faced hammer or equivalent, strike the part labeled A from the rear of the vehicle to maintain the clearance at the slide pin area.
NOTICE:
Be careful not to damage the arm.
(b) Remove the nut, washer, bolt and No. 2 suspension arm from the axle carrier.