LS 460 RWD V8-4.6L (1UR-FSE) (2010)
/Page-2087004.png)
SUSPENSION: REAR LOWER ARM: INSTALLATION
HINT
*
Use the same procedures for the RH side and LH side.
*
The procedures listed below are for the LH side.
*
A bolt without a torque specification is shown in the standard bolt chart See: Specifications/Mechanical Specifications/Standard
Bolt - Specified Torque For Standard Bolts.
1. TEMPORARILY INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY LH
(a) Temporarily install the No. 2 suspension arm with the No. 2 suspension toe adjust plate, rear suspension attachment and nut to the suspension
member.
(b) Install the stud of the suspension arm, and temporarily install a washer, nut and the bolt to the axle carrier.
2. TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY LH
(a) Temporarily install the No. 1 suspension arm with the bolt and nut to the suspension member.
(b) Install the stud of the suspension arm, and temporarily install a new nut to the axle carrier.
3. TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY LH
(a) Tighten the bolt and nut.
Torque : 72 Nm (734 kgf-cm, 53 ft-lbf for bolt)
