LS 460 RWD V8-4.6L (1UR-FSE) (2010)
Ottoman)/Installation.
22. INSTALL REAR SEAT CUSHION ASSEMBLY CENTER (for Power Seat) See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Rear Seat Assembly (for Power Seat)/Installation
23. INSTALL REAR SEAT CUSHION ASSEMBLY RH
(a) Install the seat cushion for power seat See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat Assembly (for
Power Seat)/Installation.
(b) Install the seat cushion for ottoman See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat Assembly (for
Ottoman)/Installation.
24. INSTALL REAR SEAT CUSHION ASSEMBLY LH
(a) Install the seat cushion for power seat See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat Assembly (for
Power Seat)/Installation.
(b) Install the seat cushion for ottoman See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat Assembly (for
Ottoman)/Installation.
25. INSTALL REAR WHEEL HOUSE LINER LH
(a) Install the liner with the 3 screws, 11 nuts, 2 clips to the vehicle side.
26. INSTALL NO. 6 ROCKER PANEL MOULDING PROTECTOR See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and
Repair/Installation
27. STABILIZE SUSPENSION
(a) Install the rear tires.
Torque : 140 Nm (1428 kgf-cm, 104 ft-lbf)
(b) Lower the vehicle and bounce it up and down several times to stabilize the rear suspension.
(c) Remove the rear tires.
(d) Jack up the axle carrier with a wooden block between the jack and axle carrier. Apply a load to the rear suspension so that the rear drive shaft
assembly becomes level.
28. TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH
(a) Tighten the nut on the axle carrier.
Torque : 80 Nm (816 kgf-cm, 59 ft-lbf)