LS 460 RWD V8-4.6L (1UR-FSE) (2010)
Ottoman)/Installation.
23. INSTALL REAR SEAT CONSOLE BOX ASSEMBLY (for Ottoman) See: Body and Frame/Interior Moulding / Trim/Console/Service and
Repair/Removal and Replacement/Rear Console Box (For Ottoman)/Installation
24. INSTALL REAR SEATBACK ASSEMBLY LH
(a) Install the seatback for power seat See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat Assembly (for
Power Seat)/Installation.
(b) Install the seatback for ottoman See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat Assembly (for
Ottoman)/Installation.
25. INSTALL REAR SEAT CUSHION ASSEMBLY CENTER (for Power Seat) See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Rear Seat Assembly (for Power Seat)/Installation
26. INSTALL REAR SEAT CUSHION ASSEMBLY RH
(a) Install the seat cushion for power seat See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat Assembly (for
Power Seat)/Installation.
(b) Install the seat cushion for ottoman See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat Assembly (for
Ottoman)/Installation.
27. INSTALL REAR SEAT CUSHION ASSEMBLY LH
(a) Install the seat cushion for power seat See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat Assembly (for
Power Seat)/Installation.
(b) Install the seat cushion for ottoman See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat Assembly (for
Ottoman)/Installation.
28. INSTALL REAR WHEEL HOUSE LINER LH See: Rear Shock Absorber/Installation
29. INSTALL NO. 6 ROCKER PANEL MOULDING PROTECTOR See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and
Repair/Installation
30. STABILIZE SUSPENSION
(a) Install the rear tires.
Torque : 140 Nm (1428 kgf-cm, 104 ft-lbf)
(b) Lower the vehicle and start the engine. Then fill the pneumatic cylinder assembly with rear shock absorber with air.
(c) Lower the vehicle and bounce it up and down several times to stabilize the rear suspension.
(d) Remove the rear tires.
(e) Jack up the axle carrier with a wooden block between the jack and axle carrier. Apply a load to the suspension so that the rear drive shaft
assembly is placed in a horizontal position.
31. TIGHTEN PNEUMATIC CYLINDER WITH REAR SHOCK ABSORBER ASSEMBLY LH
(a) Tighten the nut on the axle carrier.