LS 600h V8-5.0L (2UR-FSE) Hybrid (2008)
(b) Tighten the bolt and nut.
Torque: 118 Nm (1203 kgf-cm, 87 ft-lbf)
4. TEMPORARILY CONNECT PNEUMATIC CYLINDER WITH REAR SHOCK ABSORBER ASSEMBLY LH See: Rear Upper
Arm/Installation
5. INSTALL REAR STABILIZER LINK ASSEMBLY LH See: Stabilizer Bar/Service and Repair/Rear Stabilizer Bar/Installation
6. STABILIZE SUSPENSION See: Suspension Strut / Shock Absorber/Service and Repair/Rear Shock Absorber/Installation
7. TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH
(a) Tighten the nut.
Torque: 150 Nm (1530 kgf-cm, 111 ft-lbf)
(b) Tighten the nut.
Torque: 225 Nm (2294 kgf-cm, 166 ft-lbf)
8. TIGHTEN PNEUMATIC CYLINDER WITH REAR SHOCK ABSORBER ASSEMBLY LH See: Rear Upper Arm/Installation
9. INSTALL SKID CONTROL SENSOR WIRE See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel Speed
Sensor/Service and Repair/Rear Speed Sensor/Installation
10. INSTALL LOAD SENSING VALVE SENSOR BRACKET See: Sensors and Switches - Suspension/Ride Height Sensor/Service and
Repair/Height Control Sensor (for Rear LH)/Installation
11. INSTALL NO. 2 DIFFERENTIAL SUPPORT PROTECTOR See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair/Rear Drive Shaft Assembly/Installation
12. INSTALL REAR WHEEL