LX 450 L6-4.5L (1FZ-FE) (1996)
Technical Service Bulletin # AX001-96
Date: 961227
Running Board - Installation Procedures
BULLETIN NUMBER:
AX001-96
SECTION:
ACCESSORIES
DATE:
DECEMBER 27, 1996
TITLE:
LX 450 RUNNING BOARD INSTALLATION
MODEL:
LX 450
The following contains the installation procedure for the LX 450 Running board and its individual components (all parts are U.S. sourced).
RECOMMENDED TOOLS/MATERIALS:
-
13 mm Socket
-
10 mm Deep Well Socket Ratchet
-
Torque Wrench
-
10 mm Box End Wrench 12 mm Crowfoot Wrench
-
12 mm Box End Wrench 13 mm Crowfoot Wrench
-
13 mm Box End Wrench
-
Center Punch
-
1/4" Drill Bit
-
Drill
-
Drill Stop
PART NUMBER INFORMATION:
INSTALLATION PROCEDURES
Thoroughly clean all attachment areas and remove any excess undercoating as required to allow proper seating of the brackets. Inspect kit contents to
identify components before attempting installation, then follow each procedure for each side of the vehicle.
VEHICLE PREPARATION
Detach the front mudguard from the vehicle by removing the (3) 10 mm mounting screws. The mounting screws are to be saved for use in later steps.
Discard the mudguard.
Door Extension