LX 570 V8-5.7L (3UR-FE) (2010)
/Page-1609005.png)
NOTICE:
Pull out the sensor while trying as much as possible not to rotate it.
Installation
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: REAR SPEED SENSOR: INSTALLATION
1. INSTALL REAR SPEED SENSOR LH
(a) Install the speed sensor with the nut.
Torque : 8.3 Nm (85 kgf-cm, 73 in-lbf)
NOTICE:
*
Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
*
While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.
*
After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.
*
Make sure there is no foreign matter attached to the speed sensor rotor.
2. INSTALL REAR SPEED SENSOR RH
(a) Install the speed sensor with the nut.
Torque : 8.3 Nm (85 kgf-cm, 73 in-lbf)
NOTICE:
*
Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
*
While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.
*
After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.
*
Make sure there is no foreign matter attached to the speed sensor rotor.
3. INSTALL SKID CONTROL SENSOR WIRE
(a) Install the sensor clamp with the bolt.
