LX 570 V8-5.7L (3UR-FE) (2010)
(a) Check the function of SST See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.
(b) Remove the front passenger airbag See: Removal and Replacement/Front Passenger Airbag Assembly/Removal.
CAUTION:
*
When removing the front passenger airbag assembly, wait at least 90 seconds after the engine switch is turned off and the cable is
disconnected from the negative (-) battery terminal before starting work.
*
When storing the front passenger airbag, keep the airbag deployment side facing upward.
(c) Install SST.
(1) After connecting SST to each other, connect them to the front passenger airbag.
SST : 09082-00802
09082-10801
09082-30801
(d) Using a service-purpose wire harness for the vehicle, tie down the front passenger airbag to a tire.
Cross-sectional area of stripped wire harness section:
1.25 mm2 (0.00192 in.2) or more
CAUTION:
If the wire harness is too thin or an alternative object is used to tie down the front passenger airbag assembly, it may be snapped by
the shock when the airbag is deployed. Always use a wire harness for vehicle use with a cross-sectional area of at least 1.25 mm2
(0.0019 in.2).
HINT
To calculate the cross-sectional area of the stripped wire harness section: Cross-sectional area= 3.14 x (Diameter)2 divided by 4
(1) Position the front passenger airbag inside a tire with the airbag deployment side facing inside.