RX 300 FWD V6-3.0L (1MZ-FE) (1999)
4. REMOVE FRONT PILLAR GARNISHES
Insert a screwdriver between the body and front pillar garnishes to pry the garnishes.
HINT: Tape the screwdriver tip before use.
5. REMOVE COWL SIDE TRIMS
Remove the 2 clips and cowl side trims.
6. REMOVE NO.1 AND NO.2 SPEAKER PANELS
HINT: Do the same for LH and RH.
(a) Insert a screwdriver between the speaker panel and instrument panel safety pad to pry the speaker panel.
HINT: Tape the screwdriver tip before use.
(b) Disconnect the connector.
7. REMOVE NO.2 UNDER COVER
Using a screwdriver, remove the No.2 under cover.
HINT: Tape the screwdriver tip before use.
8. DISCONNECT AIRBAG CONNECTOR
(a) Using a screwdriver, pry out the glove compartment d~ finish plate.
HINT: Tape the screwdriver tip before use.
(b) Remove the airbag connector from the glove compartment door finish plate.
(c) Disconnect the airbag connector.
NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.