RX 300 FWD V6-3.0L (1MZ-FE) (1999)
HINT:
-
See the list of DTC shown.
-
If every sensor is normal, a normal code is output (A cycle of 0.25 sec. ON and 0.25 sec. OFF is repeated).
-
If 2 or more malfunctions are indicated at the same time, the lowest numbered code will be displayed 1st.
9. After doing the check, disconnect the SST from terminals Ts and E1, Tc and E1 of DLC1, and turn ignition switch OFF.
SST 09843-18020
With LEXUS Hand-Held Tester
Check the speed sensor signal
Using LEXUS hand-held tester, check the speed sensor signal.
1. Hook up the LEXUS hand-held tester to the DLC2.
2. Start the engine.