RX 300 FWD V6-3.0L (1MZ-FE) (1999)
b. Remove the 3 clips and center floor carpet covers.
c. Remove the 6 screws and lower center finish panel.
d. Disconnect the shift control cable.
e. Disconnect the 3 connectors.
f.
Remove the 4 nuts and floor shift assembly.
4. REMOVE NO.1 BRACE
a. Remove the 2 nuts and shift control cable bracket.
b. Remove the 2 nuts, 3 bolts and No.1 brace.
c. Remove the air ducts.
5. REMOVE AIRBAG SENSOR ASSEMBLY
a. Disconnect the airbag sensor connectors.
NOTE: Remove the connectors with the airbag sensor assembly installed.
b. Using a torx wrench, remove the 3 screws and airbag sensor assembly.
Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)
Installation
NOTE:
-
Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.
-
Never reuse the airbag sensor assembly involved in a collision when the airbag has deployed.
-
Never repair a sensor in order to reuse it.
1. INSTALL AIRBAG SENSOR ASSEMBLY
a. Using a torx wrench, install the airbag sensor assembly with the 3 screws.
Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)
Torque: 21 Nm (210 kgf.cm, 15 ft.lbf)
b. Connect the airbag sensor connectors.