RX 300 FWD V6-3.0L (1MZ-FE) (1999)
1. INSTALL FRONT AIRBAG SENSOR
a. Install the front airbag sensor with the arrow on the sensor facing toward the front of the vehicle.
Torque: 20 Nm (205 kgf.cm, 15 ft.lbf)
NOTE:
-
Make sure the sensor is installed with the specified torque.
-
If the sensor has been dropped, or there are cracks, dents or other defects in the case, brackets or connector, replace the removed sensor,
with new ones.
-
The front sensor is equipped with an electrical connection check mechanism. Be sure to lock this mechanism securely when connecting the
connector. If the connector is not securely locked, a malfunction code will be detected by the diagnostic system.
b. Connect the front airbag sensor connector.
2.
INSTALL REMOVED PARTS