RX 300 FWD V6-3.0L (1MZ-FE) (1999)
-
If the contact plate is not pressed down with the specified pressure, the contact plate may tilt due to deformation or the tightening of the
nut.
2. Using SST tighten the nuts to the specified torque.
SST 09810-38140
Torque: 17 Nm (173 kgf.cm, 13 ft.lbf)
NOTE: If the nut is over tightened, it may cause cracks on the inside of the insulator.
h. Clean the contact surfaces of the remaining contact plate and plunger with a dry shop rag.
i.
Reinstall the plunger, new gasket and end cover with 3 bolts.
Torque: 2.5 Nm (26 kgf.cm, 23 in. lbf)