RX 300 FWD V6-3.0L (1MZ-FE) (1999)
3. INSTALL STEERING RACK
a. Install SST to the rack.
SST 09631-33010
HINT: If necessary, scrape the burrs off the rack teeth end and burnish.
b. Coat the SST with power steering fluid.
c. Install the rack into the rack housing.
NOTICE: Be careful not to damage the oil seal lip.
d. Remove SST.
4. INSTALL BUSHING
a. Coat a new O-ring with power steering fluid and install it to the bushing.
b. To prevent oil seal lip damage, wind vinyl tape on the steering rack end, and apply power steering fluid.
c. Install the bushing.
NOTICE:
-
Make sure to install the bushing facing the correct direction.
-
Be careful not to damage the oil seal lip.
5. INSTALL CYLINDER END STOPPER
a. Align the installation hole for the wire of the stopper with the slot of the rack housing.
b. Install a new wire into the stopper.